Gizmocoding Forums

Good afternoon,
Installed it on my desktop (WIN10), assigned a fixed network IP address 192.168.121.108 to Dashcamera and entered that into the BV software.
Activated cloud on my Blackvue dr900s-2ch and connected to my wifi network ok.
When I start driving up driveway I get the voice message "not registered" or like from the DC.
So I assume that WIFI connection is ok strength wise etc, when garaged car would only be 10 feet away from the WIFI transmitter, car is located on
the lower level separated by carpeted wooden floor.
I can the see that the assign IP address is active on my network, according to my router (Pfsense) just after I arrive home.
But I am unable to get Blackvue Down loader to connect and do its thing.
Any clues what might be blocking it, it can obviously connect to Blackvue Cloud, but not my local PC.
I am thinking that maybe something in WIN10 is blocking the connection?
Installation instructions look straightfoward and I can't find anything that I missed.

Hi

Sorry to hear about troubles:

Check in a web browser:

http://10.99.77.1/Config/config.ini

Or

http://10.99.77.1/blackvue_vod.cgi

Changing 10.99.77.1 IP address to what you think the IP address is

If works - probably firewall or similar network setting for BVD app, if doesn’t work something up with you camera network connection

Glenn


Sent from my iPhone using Tapatalk

Hi Glenn,

Many thanks for the prompt reply, will investigate the suggestions above when I get home later this evening.

Thanks
Gregg